Configuration

• Photo of the Test Board, "LizBoard3", and chip layout
• Test Board; layout and dimensions
• Interface Board; photo, layout and dimensions (coming soon)

Test Procedure

• Prior to the test, prepare the test setup as follows:
  1. Connect power lines to the interface board
  2. Connect signal lines to the interface board
  3. Connect the interface board to the test board
  4. Turn on the power supply and the logic analysis system
  5. Output the voltages on the power lines
  6. Start the LabVIEW program for the test
• For each ion species and beam energy, perform a run as follows:
  1. Establish the ion-beam
  2. Press "Begin Run" button on the LabVIEW panel to start a run
  3. Type a file name of a log file in a dialog box popping up
  4. Monitor a run logging on the LabVIEW panel during irradiation
  5. Press "End Run" button on the LabVIEW panel to stop the run
• At the end of the beam-test, terminate the system as follows:
  1. Terminate the LabVIEW program
  2. Turn off the voltages on the power lines
  3. Turn off the power supply and the logic analysis system
  4. Disassemble the test setup