Summaries

• User Guide of BTEM Tracker briefly describes the BTEM tracker for non-tracker-experts and gives details about the tracker for tracker experts. For tracker experts, tracker configuration, coordinate system, required instruments to run the tracker, etc., are described.
• Summary of Construction lists test results of HDI's, bad strips, detector ladders, and detectors obtained during the BTEM construction.
• Timing diagram for the TEM-FEE interface
• Taka'sbad channel list @ SLAC

BTEM Tracker Design

• Prototype Tower Design Overview of the design of the tracker subsystem of the GLAST prototype tower. SCIPP 98/28.
• Tray assembly precision for the GLAST Si tracker
• Mass of GLAST BTEM Tray Electronics Assemblies
• Tracker Section of the ATD Closeout Report Overview of the design of the BTEM tracker subsystem of the GLAST prototype tower.

Assembly

• Naming convention Descriptions of naming convention of detector, ladder, wire-bond, HDI, and tray for the BTEM tracker
• Tracker Construction Report Detailed discussion of BTEM tracker construction including recomendations for improvments and manufacturing yield data.
• Tracker Assembly Procedures Documents on step-by-step assembly procedures of the BTEM tracker
• Hybrid Bonding Instructions (PDF) (MS Word) Instructions given to assembly house that wire bonded the hybrid circuit board.
• Manual of Electrical Test Setup describes the setup for electrical functionality test of GLAST BTEM tracker front-end electronics.
  The complete list of the tests actually performed is available [PostScript (256 kB), PDF (120 kB)].
  Here are actual command files for GTFE64c, GTRC/B, and HDI.

Disassembly and Repair for Balloon Flight (2001)

• Disassembly procedure by Gwelen

Send your suggestions or complaints about this page to Masaharu Hirayama

Last modified: Sun Oct 8 17:37:12 PDT 2000